Where to begin with 7I76E card?
- txtrone
-
Topic Author
- Offline
- Platinum Member
-
Less
More
- Posts: 384
- Thank you received: 106
08 Nov 2020 20:20 #188691
by txtrone
Where to begin with 7I76E card? was created by txtrone
I have the 7I76E powered up and connected to my LinuxCNC computer. I have two NICs and did a ping test with each, chose the fastest. What is the next logical step? My intended use is a 4 axis plasma table.
Do I need to connect to the card in the Plasmac? Or upgrade firmware first?
Do I need to connect to the card in the Plasmac? Or upgrade firmware first?
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 20177
- Thank you received: 6868
08 Nov 2020 21:00 #188694
by tommylight
Replied by tommylight on topic Where to begin with 7I76E card?
forum.linuxcnc.org/plasmac/37234-plasmac-documentation
No need to upgrade firmware, i think.
No need to upgrade firmware, i think.
Please Log in or Create an account to join the conversation.
- txtrone
-
Topic Author
- Offline
- Platinum Member
-
Less
More
- Posts: 384
- Thank you received: 106
08 Nov 2020 21:07 #188697
by txtrone
Replied by txtrone on topic Where to begin with 7I76E card?
Ok, I know I have seen some wiring diagrams on here for this Mesa card. I will look around some.
Please Log in or Create an account to join the conversation.
- JohnnyCNC
-
- Offline
- Platinum Member
-
Less
More
- Posts: 562
- Thank you received: 106
08 Nov 2020 21:32 #188699
by JohnnyCNC
Replied by JohnnyCNC on topic Where to begin with 7I76E card?
Please Log in or Create an account to join the conversation.
- txtrone
-
Topic Author
- Offline
- Platinum Member
-
Less
More
- Posts: 384
- Thank you received: 106
08 Nov 2020 22:03 #188704
by txtrone
Replied by txtrone on topic Where to begin with 7I76E card?
Thanks! That's the one!
Please Log in or Create an account to join the conversation.
Moderators: PCW, jmelson
Time to create page: 0.222 seconds