7i76E Stock ?

MESA sold out of them again. The FPGA that the board has been designed with is extremely
expensive now and from what I understand a replacement board is in the works with a different
FPGA chip.

Did you get some a few days back?
You wanted more?
I am getting low on Mesa also, and since we are here, PCW, is there a firmware for 7i95 with 7i77? I do not need it right now, but i might have to return the 7i92 to the machine i borrowed it from.

Yes. I got the 2 ordered that I needed plus 2 more for a couple other machines I have my eye on.
Though once I have the two 7i76E's installed in their respective machines I will have two 7i96
NON S versions that I most likely wont need anymore. This Linuxcnc stuff is an addiction. image missing /media/kunena/emoticons/devil.png

my1987toyota wrote:

This Linuxcnc stuff is an addiction.

People collect old strange paintings, i collect Mesa boards!
And right now i really really need a 7i72, like right now, not after a month. By then i will cobble together some 30 odd inverted outputs!

my1987toyota wrote:

Yes. I got the 2 ordered that I needed plus 2 more for a couple other machines I have my eye on.
 

or at least I thought I had got two more ordered before they ran out. I had been so busy at work that
I didn't check my email for a few days ( long days too tired ). It was only Later that I found out the 2nd
order got canceled because I didn't confirm in time. Unfortunately Mesa is not going to have the
7i76E in stock until the new design is out.

Hey Tommylight I see EUsurplus has some 7i72's in stock. I am not sure if customs would be
the limiting factor time wise.