Forum Menu

7I96 Encoder Spindle tuning

More
2 years 7 months ago #294937 by PCW
Replied by PCW on topic 7I96 Encoder Spindle tuning
Can you post a link to the manual here?
 

Please Log in or Create an account to join the conversation.

More
2 years 7 months ago #294974 by kbec
Replied by kbec on topic 7I96 Encoder Spindle tuning
I have the 240-DS if it matters, The motor runs fine when attached to the potentiometer that came with it. 

Please Log in or Create an account to join the conversation.

More
2 years 7 months ago #294975 by PCW
Replied by PCW on topic 7I96 Encoder Spindle tuning
With the 5K potentiometer attached what is the voltage across the potentiometer?
(from P3 to P1)

Be careful when measuring as these connections are not isolated from the line voltage

Please Log in or Create an account to join the conversation.

More
2 years 7 months ago #295055 by kbec
Replied by kbec on topic 7I96 Encoder Spindle tuning
6.3v no matter the speed

Please Log in or Create an account to join the conversation.

More
2 years 7 months ago #295061 by PCW
Replied by PCW on topic 7I96 Encoder Spindle tuning
So a 6V isolated supply should work

Note that isolation is key here, a non-isolated suppy
will cause damage

Please Log in or Create an account to join the conversation.

More
2 years 7 months ago #295062 by kbec
Replied by kbec on topic 7I96 Encoder Spindle tuning
Where would I connect that to? The 7i96 or Spinx1?

Please Log in or Create an account to join the conversation.

Moderators: PCW, jmelson
Time to create page: 0.089 seconds
Powered by Kunena Forum