Verify my Mesa selection
31 Jul 2024 14:10 #306525
by RotarySMP
Replied by RotarySMP on topic Verify my Mesa selection
Oh how cool is that. Yeah definitely wire them into the three surplus encoder inputs on the 7i97.
Would be very cool if you could connect that Heidenhain control panel into LinuxCNC as well. Do you have info about it? Is it a matrix keyboard?
Would be very cool if you could connect that Heidenhain control panel into LinuxCNC as well. Do you have info about it? Is it a matrix keyboard?
Please Log in or Create an account to join the conversation.
- Krulli_Fräser
- Offline
- Junior Member
-
Less
More
- Posts: 33
- Thank you received: 2
01 Aug 2024 04:30 #306582
by Krulli_Fräser
Replied by Krulli_Fräser on topic Verify my Mesa selection
I have already made a deal with a used electronics seller. The Heidenhain components will be sold and the money from that more than covers all components for the retrofit.I weel keep the middle panel because i can wrap my head around how the small keypad and the cycle start/stop buttons are wired. In the bottom I will just use a USB keyboard and encoders for JOG/SPEED/FEED.
The following user(s) said Thank You: RotarySMP
Please Log in or Create an account to join the conversation.
02 Aug 2024 10:07 #306712
by RotarySMP
Replied by RotarySMP on topic Verify my Mesa selection
That makes sense.
Please Log in or Create an account to join the conversation.
Time to create page: 0.064 seconds