Retrofiting a Paxton/Paterson Training Center Mill.

tommylight
Away
Moderator

25 May 2017 22:17 #93640 by tommylight

Replied by tommylight on topic Retrofiting a Paxton/Paterson Training Center Mill.

For those BOB's the base thread has to be near or at 100.000 or they just do not work. That is if using paraport.
Sorry if i missed something, been busy lately.

The following user(s) said Thank You: Livoniany

Please Log in or Create an account to join the conversation.

Livoniany
Offline
New Member

26 May 2017 00:52 #93648 by Livoniany

Replied by Livoniany on topic Retrofiting a Paxton/Paterson Training Center Mill.

Hello Thank you everyone for your help. My friend and I bypassed the board and ran it directly from the parallel cable. The axis ran as expected.

Please Log in or Create an account to join the conversation.

Livoniany
Offline
New Member

26 May 2017 01:00 #93649 by Livoniany

Replied by Livoniany on topic Retrofiting a Paxton/Paterson Training Center Mill.

Hello Thank you everyone for your help. My friend and I bypassed the board and ran it directly from the parallel cable. The axis ran as expected.

Please Log in or Create an account to join the conversation.

Moderators: cncbasher

Time to create page: 0.071 seconds