Sprutcam Postprocessor for LinuxCNC
- ChrisB
- Offline
- Junior Member
-
Less
More
- Posts: 26
- Thank you received: 0
17 Oct 2014 02:22 #52145
by ChrisB
Sprutcam Postprocessor for LinuxCNC was created by ChrisB
Hi
has anybody written a postprocessor for sprutcam an linuxcnc?
Thank you
Christian
has anybody written a postprocessor for sprutcam an linuxcnc?
Thank you
Christian
Please Log in or Create an account to join the conversation.
- cncbasher
- Offline
- Moderator
-
Less
More
- Posts: 1744
- Thank you received: 288
17 Oct 2014 21:59 #52159
by cncbasher
Replied by cncbasher on topic Sprutcam Postprocessor for LinuxCNC
what version of sprutcam ? , i'm not directly aware of one , however i do have a post for mach3 , and as sprutcam post processors are text based
it should not take you long to modify for linuxcnc , i.e change tap to ngc etc
it should not take you long to modify for linuxcnc , i.e change tap to ngc etc
Please Log in or Create an account to join the conversation.
- jonesturf
- Offline
- Senior Member
-
Less
More
- Posts: 56
- Thank you received: 1
29 Oct 2014 08:45 #52517
by jonesturf
Replied by jonesturf on topic Sprutcam Postprocessor for LinuxCNC
Ha I was just going to post this same question. Would really like to play around with SprutCAM but only if there's a post processor. Not up on coding my own quite yet.
Please Log in or Create an account to join the conversation.
Time to create page: 0.088 seconds