possible error in docs 2.8.0-pre1 man halui

when typing man halui in terminal I was getting this under axis section:

axis (L = axis index (0:x 1:y 2:z 3:a 4:b 5:c 6:u 7:v 8:w))
halui.axis.L.select bit in
pin for selecting axis by index


axis jogging (L = axis letter (xyzabcuvw)
halui.axis.jog-deadband float in
pin for setting jog analog deadband (jog analog inputs
smaller/slower than this (in absolute value) are ignored)


I assume L should be a letter not a number as Illustrated on the lower example?

man page update (2.8): github.com/LinuxCNC/linuxcnc/commit/d433aace2
thanks for report