Place to post Configurations? Hardinge CHNC retrofit
06 Nov 2023 16:26 #284717
by Dbsharp
Place to post Configurations? Hardinge CHNC retrofit was created by Dbsharp
Hi I a not sure if there is a spot to share working configurations, so I am putting this here for now. I expect these might be useful for others to see what worked.
Attachments:
Please Log in or Create an account to join the conversation.
20 Nov 2023 11:08 #286017
by andypugh
Replied by andypugh on topic Place to post Configurations? Hardinge CHNC retrofit
You could consider putting it on the Wiki (wiki.linuxcnc.org) though it's debatable where it is most likely to be found.
Please Log in or Create an account to join the conversation.
Time to create page: 0.062 seconds