- Other Stuff
- Forum Questions
- Help: Error You have too many links in your message, please decrease them!
Help: Error You have too many links in your message, please decrease them!
- hachi
- Offline
- Junior Member
-
Less
More
- Posts: 31
- Thank you received: 3
01 May 2024 22:48 #299513
by hachi
Help: Error You have too many links in your message, please decrease them! was created by hachi
I don't know why this is showing up, my forum post that I created has zero links in it. This might be because of [code] blocks or square brackets from output in LinuxCNC parts, but I don't see any way to mark text as 'literal' rather than special forum codes.
Attached as a txt file is the body source I tried to post.
Attached as a txt file is the body source I tried to post.
Attachments:
Please Log in or Create an account to join the conversation.
- andypugh
-
- Away
- Moderator
-
Less
More
- Posts: 23558
- Thank you received: 4858
04 May 2024 09:45 #299707
by andypugh
Replied by andypugh on topic Help: Error You have too many links in your message, please decrease them!
I imagine that the dumb forum software is interpreting QTVCP.X.Y as links (even though they are in code blocks)
Maybe try re-posting with them all replaced by commas, and with an explanatory note?
Maybe try re-posting with them all replaced by commas, and with an explanatory note?
Please Log in or Create an account to join the conversation.
- Other Stuff
- Forum Questions
- Help: Error You have too many links in your message, please decrease them!
Time to create page: 0.069 seconds