Using Linux CNC for 6-DOF stewart platform
- avaneeshritwik
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
09 Jun 2016 09:04 #75711
by avaneeshritwik
Using Linux CNC for 6-DOF stewart platform was created by avaneeshritwik
I have created a 6-DOF stewart platform for 3D printing. I was wondering if i could use linux CNC to control the setup, I will be using 6 stepper motors for controlling the position and orientation of the tool head. I am new to the linux environment and if i could get some direction on how to proceed along this line?
Please Log in or Create an account to join the conversation.
09 Jun 2016 13:34 #75723
by andypugh
Yes. Have a look at the simulated hexapod configuration.
Replied by andypugh on topic Using Linux CNC for 6-DOF stewart platform
I have created a 6-DOF stewart platform for 3D printing. I was wondering if i could use linux CNC to control the setup,
Yes. Have a look at the simulated hexapod configuration.
Please Log in or Create an account to join the conversation.
Time to create page: 0.065 seconds