howto setup a bipodkins 2axis with 2.8 source
- ktchk
- Offline
- New Member
-
Less
More
- Posts: 8
- Thank you received: 0
21 Jan 2017 17:41 #86377
by ktchk
howto setup a bipodkins 2axis with 2.8 source was created by ktchk
with 2.8 source how can I change kinematic with bipodkins.c from machinekit and make a 2 axis machine?
Please Log in or Create an account to join the conversation.
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 19678
- Thank you received: 4559
22 Jan 2017 22:58 #86442
by andypugh
Replied by andypugh on topic howto setup a bipodkins 2axis with 2.8 source
bibodkins is probably simple enough that you can just get the file and compile/install it to LinuxCNC with halcompile.
sudo halcompile --install bipodkins.c
I think that bipodkins probably came from here: wiki.linuxcnc.org/cgi-bin/wiki.pl?Koppi's_Toy
(I doubt any of those links work any more)
sudo halcompile --install bipodkins.c
I think that bipodkins probably came from here: wiki.linuxcnc.org/cgi-bin/wiki.pl?Koppi's_Toy
(I doubt any of those links work any more)
Please Log in or Create an account to join the conversation.
Time to create page: 0.074 seconds