Joint error messages

I get a error message at the start of the program advising me that joint 0 which I think is the Z axis exceeds the positive direction and joint 1 which I assume is the Y axis exceeds the positive direction. I have rechecked my homing and also the travel . I have sufficient travel in the positive and the negative direction for all of the axeses. Any thought Please.

Post the Program and your ini file. So we can stop guessing.

Best,
Udo

Thank you for getting back to me so quickly . I do not know what you mean regarding the Ini file . The ngc file is developed using Cut2d and the execution program is EMC2 , 2.4.6

Chipmunk wrote: Thank you for getting back to me so quickly . I do not know what you mean regarding the Ini file . The ngc file is developed using Cut2d and the execution program is EMC2 , 2.4.6

The HAL and INI files will be in the Linuxcnc config folder

Thanks for the reply I will be at the machine tomorrow and I will dig that info out.

Hello Linux I think I found the problem but I will need to reconfigure my travel X,Y,Z travel in Stepcon,.My machine is a Taig with a 16 inch bed For some reason my Stepcon settings have changed. The settings for the machine should be x, 12 in, it is at 8 ,.Y should be 5.5 ïn, and it is also at 8 and Z should be 6 in but it shows up as-4. I will change these settings to what they should be and try again. In trying to test the settings in Devcon I can't seem to get the test button to work . Have you any suggestions.? One other question, I have downloaded Wheezy and am running it on a separate machine. I went into Defcon but it does not support Taig. It supports Sherline could i use that to set up the Taig? Thank You