Error on start unexpected realtime delay task 0 or task1

More
6 years 5 months ago #166759 by gzcwnk
I have tried a lot of settings 2000 up to 15000 and no joy

Please Log in or Create an account to join the conversation.

More
6 years 5 months ago #166762 by tommylight
Set it to 50000 and test again.
Did you disable everything regarding power savings in BIOS ?

Please Log in or Create an account to join the conversation.

More
6 years 5 months ago #166791 by gzcwnk
Yes, original test was 4600 and that didnt work. So reading posts here itsaid Nvidia cards can do it so I pulled the Quadro and put in a AMD 4850/4860. Next I went through and turned off all power saving and speed step stuff I could find, that dropped the test to 2600 (which is interesting in itself). I will have a go at 50000, but that's un-usable? and for a 3.4ghz i7 with 16gb of ram seems, terrible?

Please Log in or Create an account to join the conversation.

More
6 years 5 months ago #166792 by tommylight

gzcwnk wrote: I will have a go at 50000, but that's un-usable? and for a 3.4ghz i7 with 16gb of ram seems, terrible?

It is very usable, it can still do 20000 pulses per second, and later when you have everything working you can try to lower it if you eventually need more velocity.

Please Log in or Create an account to join the conversation.

More
6 years 5 months ago #166793 by gzcwnk
same error at 50000 on start up.

Please Log in or Create an account to join the conversation.

More
6 years 5 months ago #166794 by gzcwnk
Latency test is 300 ish. I will pull the hd, put another in and try the newer LinuxCNC on stretch but I had a very similar error off the usb key.

Please Log in or Create an account to join the conversation.

Time to create page: 0.353 seconds
Powered by Kunena Forum