XHC-WHB04B-4 can't get it too work.

So I have managed to get 2.9 installed but I can't seem to figure out how to get the XHC-WHB04B-4 pendant to work.
Do I use Pncconfig to install it, I'm having a tough time because I have never used Linux before. I have Linux Mint installed with linuxcnc 2.9 on it.
Is there maybe a step by step installation page or video that I just haven't found yet?
Any help to point me in the right direction would be appreciated.
Thanks Mike

hi
does it response in the terminal
i added my config so you can see if it workes propper

Hi

you can check here forum.linuxcnc.org/38-general-linuxcnc-q...king?start=90#164533

Br

I just can't seem to figure this out, is there a step by step procedure somewhere that i could use, I've tried everything that I can, I feel so stupid because I'm just learning linux.
Already spent days on this. I don't care about what the buttons are setup for as long as I can jog x,y and z.
Anyone willing to take time too help me out I would be willing to pay for your time.
Thanks Mike

add me to skype and ican try to help

alkabal wrote: add me to skype and ican try to help : golfopeos[/quote

Ok thanks alot, I will add you to my Skype.