Total Machine time

Glad you figure it out. Looks like i need learn Python too...the minimum.

Me too :dry:

Next thing is the remote control of my air compressor.
I installed the Shelly yesterday :side:

How do you intend to connect the shelly.
What i found is that it should be possible to use plcopen to convert the Shelly into a ModBusTCP remoteIO. Using arduino ide. Did that for an oak device, was not too difficult.
Mike

They have an http api you can use I wrote a python hal module for me:

forum.linuxcnc.org/38-general-linuxcnc-q...uxcnc?start=0#178821

You can actually also analyse the feedback from the Shelly if you want and do a lot more, but for me this is enough.

If it works (i saw your youtube) that is good enough. Congrats.
I'm a bit concerned that shelly does not make possible to use encription if you do not use their cloud solution. I totaly dislike such 'forced remote in'.
Mike

None of my Shellys are in the cloud. I don’t see the point in my network I think you can use passwords but I didn’t check for https. If someone brakes intime network the Shellys are the least of my concerns