Joint following error right after clicking on Machine Power ON (7i97 LCNC 2.9)

Hi again Peter!,
One very strange issue we found.
When we are plugging in the x axis encoder from the drive to the joint 0 input we get the above mentioned problems.

As a last resort we swapped the x axis encoder and y axis encoder on the mesa side. So now if we rotate the Y axis ball screw by hand X axis see the change in DRO. When we rotated the Y axis by hand, X axis immediately started to correct the change by rotating in the opposite direction. The speed at which X tries to correct is also very high.

When we swap the encoder connections back to the correct configuration (x axis to x axis drive encoder and same for y) we get the same error where pwmgen0.value is saturated to 10 but the analog output on mesa pin is a few milivolts.

Is the encoder scaled properly? (you should be able to check this
with the drives disabled if you can turn the ballscrews by hand)
Yes we are getting exactly 5mm/ rev

Did you verify the you can get +- 10V out of the 7I97?
Yes its verified, if we remove X –axis encoder connection from mesa X-axis o/p goes to +-10V (PWM gen value=voltage at mesa). But if we plug in X-axis encoder we get only a very fraction of PWMgen value @ mesa O/P.( say at PWMgen=10 mesa o/p= 20 mV Only).
what can be the reason for mesa o/p not matching PWMgenvalue when feedback is present. ?I think we ruled out mesa hardware fault as o/p comes when no feedback is present

Sounds like you have a wiring error so you have the analog output connected to the drives ground. As soon as you make the encoder ground connection to the drive, you short out the analog output.

May be .When I connect Y axis encoder to mesa x-axis , it works, and motor runs at max speed. Very strange.
One question
Is there any further processing of PWMgenvalue before dumped being to mesa write function?.

Is there any further processing of PWMgenvalue before dumped being to mesa write function?.

No, other than being scaled and offset by the appropriate hal pins

Hi,
guess you were right . I removed the encoder GND , and voltage started rising and X-axis started responding as expected. Now X-axis is hunting a little bit upon power on . holds position at a voltage of ~0.23V. I think it can be corrected in servo.
On Y axis as soon as I switch on axis moves in + direction violently and trips with following error. I tried changing sign of encoder scale and input scale ,but results were same. (Tried all 4 combinations of signs). I swapped the analogue lines same result , but movement in opposite direction.(-).
Similar behavior in Z-axis also.
Any Idea Why this is happening?
Thanks