make M7 & M8 a pulse instead continuous on?
- davidcnc
- Offline
- New Member
-
Less
More
- Posts: 8
- Thank you received: 0
10 May 2022 17:56 #242508
by davidcnc
make M7 & M8 a pulse instead continuous on? was created by davidcnc
Need to toggle mist & flood on or off each time entered in the G code. If M9 reverses the code state no problem would be useful.
If this has been previously dealt with please direct me.
Thank You Dave Nichols
If this has been previously dealt with please direct me.
Thank You Dave Nichols
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19479
- Thank you received: 6532
10 May 2022 18:03 #242509
by tommylight
Replied by tommylight on topic make M7 & M8 a pulse instead continuous on?
Perhaps thisor this
http://linuxcnc.org/docs/2.8/html/man/man9/toggle2nist.9.htmlhttp://linuxcnc.org/docs/stable/html/man/man9/flipflop.9.htmlPlease Log in or Create an account to join the conversation.
- spumco
- Offline
- Platinum Member
-
Less
More
- Posts: 1831
- Thank you received: 741
10 May 2022 20:16 #242519
by spumco
Replied by spumco on topic make M7 & M8 a pulse instead continuous on?
Regarding the mist/flood thing, are you trying to get them to pulse while active? i.e. "M7" starts a on-off-on-off cycle and "M9" stops the cycle?
Or something else?
Otherwise, M9 shuts off both M7 & M8 like normal controls.
Or something else?
Otherwise, M9 shuts off both M7 & M8 like normal controls.
Please Log in or Create an account to join the conversation.
Time to create page: 0.047 seconds