XYYZAC Setup...
22 Jun 2013 03:35 #35900
by eslavko
XYYZAC Setup... was created by eslavko
Hello...
Is it there any way to setup XYYZAC machine with Pncconf?
In dropdown I got just XYZ and XYZA
I assume that I should use ZYZA and manualy add another Y and C.
Or is there better way?
Is it there any way to setup XYYZAC machine with Pncconf?
In dropdown I got just XYZ and XYZA
I assume that I should use ZYZA and manualy add another Y and C.
Or is there better way?
Please Log in or Create an account to join the conversation.
22 Jun 2013 14:45 #35911
by cncbasher
Replied by cncbasher on topic XYYZAC Setup...
manualy add the additional axis is the easiest way
Please Log in or Create an account to join the conversation.
Moderators: cmorley
Time to create page: 0.195 seconds