PnCConf vs. Raspberry Pi 5
- ckuecker
- Offline
- Junior Member
-
Less
More
- Posts: 35
- Thank you received: 2
02 Jan 2025 01:22 #317842
by ckuecker
PnCConf vs. Raspberry Pi 5 was created by ckuecker
Hello,
I've got a home built router running a Raspberry Pi 4 with a Mesa 7196s via Ethernet. Running AXIS. Works fine.
Interested in trying the Rpi5 - loaded the image off the download page and the board can communicate with the Mesa board, but PnCConf keeps giving errors when I try to go past the first axis page - a long dump mentioning a problem with the locale.
Any suggestions? This is an 8GB RPi5 I just got from Digi-Key.
I've got a home built router running a Raspberry Pi 4 with a Mesa 7196s via Ethernet. Running AXIS. Works fine.
Interested in trying the Rpi5 - loaded the image off the download page and the board can communicate with the Mesa board, but PnCConf keeps giving errors when I try to go past the first axis page - a long dump mentioning a problem with the locale.
Any suggestions? This is an 8GB RPi5 I just got from Digi-Key.
Please Log in or Create an account to join the conversation.
- cornholio
-
- Offline
- Platinum Member
-
Less
More
- Posts: 1127
- Thank you received: 373
02 Jan 2025 01:49 #317844
by cornholio
Replied by cornholio on topic PnCConf vs. Raspberry Pi 5
run the menu-config (menu_config) and set the locale.
This page (read the whole thing) may help
forum.linuxcnc.org/forum/search?query=LC_ALL&childforums=1
This page (read the whole thing) may help
forum.linuxcnc.org/forum/search?query=LC_ALL&childforums=1
The following user(s) said Thank You: ckuecker
Please Log in or Create an account to join the conversation.
Moderators: cmorley
Time to create page: 0.053 seconds