Probe Calibration Renishaw MP12

I am getting there it is just slow work in progress here

Hello

would you benefit from the routines of Renishaw MP12 & TS27R?
I just converted a micron VCE1000 (Haas) to Linuxcnc.
On the old controller the Renishaw routines were stored and I have the original Renishaw disk.

Greetings

Hi Sviper,

It would help very much!
I have started to try to create a replica of the macros, but it's a heck of a job!

Hello Sviper,

Yes it would very helpful to be able to run these in LCNC.

Hello

I would make them available to you, but I would not like to post them here in the forum.
I don't know what kind of license rights are on it.
Is there a possibility to send a PN here in the forum? I can't find this function.

Greetings

There is no PM function here on the forum.

you can send email to me