Tracking down "Unknown oword" message?
04 Dec 2020 03:42 #191007
by JetForMe
Tracking down "Unknown oword" message? was created by JetForMe
When I abort execution of my programs, Axis pops up "Unknown oword number", but doesn't give me any more context. I've looked at a couple NC files that might've been causing this, but they seem okay.
Is there any way to figure out what it's complaining about?
Is there any way to figure out what it's complaining about?
Please Log in or Create an account to join the conversation.
- tommylight
- Away
- Moderator
Less
More
- Posts: 18794
- Thank you received: 6313
12 Dec 2020 17:29 #191747
by tommylight
Replied by tommylight on topic Tracking down "Unknown oword" message?
Seen that once or twice when stopping a running gcode with no owords, but it does not change anything, the machines works as usual so i did not bother with it.
Is this happening on a plasma with PlasmaC?
Is this happening on a plasma with PlasmaC?
Please Log in or Create an account to join the conversation.
Time to create page: 0.058 seconds