code G71
- skipper
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
- Aciera
-
- Offline
- Administrator
-
Less
More
- Posts: 4649
- Thank you received: 2069
13 Jan 2026 07:02 - 14 Jan 2026 07:25 #341341
by Aciera
Replied by Aciera on topic code G71
you already have a thread asking about the exact same topic:
forum.linuxcnc.org/38-general-linuxcnc-q...7775-code-g71#338257
Please continue there.
You have been given a working example gcode. Have you tested that?
Also, you are not providing much information to go on.
Usually a good idea to provide a minimal example of gcode with an explanation of what exactly is not working how you expect it to.
forum.linuxcnc.org/38-general-linuxcnc-q...7775-code-g71#338257
Please continue there.
You have been given a working example gcode. Have you tested that?
Also, you are not providing much information to go on.
Usually a good idea to provide a minimal example of gcode with an explanation of what exactly is not working how you expect it to.
Last edit: 14 Jan 2026 07:25 by Aciera.
The following user(s) said Thank You: tommylight
The topic has been locked.
Time to create page: 0.072 seconds