Gscreen - a GTK / Glade / Python based screen

Thanks Chris

Working on re-compiling now, as for the tool offset patch, we have our tool table set-up with tools 1-7, 11-17 and 10001-100017. The last ones, 10001-100017 are where you enter the amount of fine adjustment or "wear" to be applied to that tool. Even in Diameter mode you have to enter that value in radius though. When you call a tool say T0101 the last two numbers are what offset to call, which dosen't have to be the same as the tool number, you could theoretically use a couple different offset values, T0101, T0102, T0103, for different diameters on a single part to get every dimension dialled in exactly.

Rick

Rick ,
could you kindly post a tool.tbl file , i'm trying to get head around the layout and values etc
i'm making a mistake somewhere .. haha

No Problem,

If I figured it anybody can, LOL

Rick

---

I don't honestly know what happened, but I swear I attached my tool file when I sent this reply. If I have a copy at home I will send it to you in a little while, if not first thing tomorrow.

Sorry about that CNCBasher

She's up and flyin now,

Thanks for the help guys,

We will do some test trials and let you know how things go.

Thanks Again everyone,

Rick

Hello Chris

I noticed one thing today, not a showstopper by any means, would there be a way to utilize the extra button in the debug menu to open up classicladder?

Thanks

Rick

Here is my tool.tbl file in .txt format.




Thanks


Rick