Glade File and Handler file Location
- mmt
- Offline
- Premium Member
-
Less
More
- Posts: 124
- Thank you received: 2
26 Nov 2019 03:31 #151282
by mmt
Glade File and Handler file Location was created by mmt
I am running Debian 7 Wheezy and linuxcnc 2.7.14
Where is the glade file and handler for Gscreen Lathe located at?
Thanks
Kent
Where is the glade file and handler for Gscreen Lathe located at?
Thanks
Kent
Please Log in or Create an account to join the conversation.
- cmorley
- Offline
- Moderator
-
Less
More
- Posts: 7760
- Thank you received: 2055
26 Nov 2019 13:59 #151296
by cmorley
Replied by cmorley on topic Glade File and Handler file Location
in a RIP system:
/share/linuxcnc/gscreen.glade
It doesn't use a handler file for that screen.
Other screens are found here (RIP)
share/gscreen/skins/
If yours is an installed version I would need to look that up.. probably /usr/share/linuxcnc/
Chris
/share/linuxcnc/gscreen.glade
It doesn't use a handler file for that screen.
Other screens are found here (RIP)
share/gscreen/skins/
If yours is an installed version I would need to look that up.. probably /usr/share/linuxcnc/
Chris
Please Log in or Create an account to join the conversation.
- mmt
- Offline
- Premium Member
-
Less
More
- Posts: 124
- Thank you received: 2
26 Nov 2019 14:18 #151297
by mmt
Replied by mmt on topic Glade File and Handler file Location
Thank you
Please Log in or Create an account to join the conversation.
Moderators: HansU
Time to create page: 0.051 seconds