THC config that works.

BosniaCNC wrote: Tommylight:
"Bosniacnc did you mange to get it working ? Bosanac jesi uspio da testujes masinu?"

Dear friend,
ESTOP button does not respond, and it drives me crazy! All variants have tried and not to include.
Tomorrow I'll put up here correction in hal file.

Sve sam pokušao i neće da uključi. Limit Z sam stavio pod # i ne reaguje. Sutra ću ti ovde postaviti kopije.
Pozdrav

Gde nestade????
Did you download the new files ? give it a try and let me know how it goes.

Here I am (online). I installed version 2.6 and I see how it works.
I just set up the configuration of the EDM Charmilles Roboform 400,
View:
www.linuxcnc.org/index.php/english/forum...form-400-sinking-edm
Regards!

P.S. Moram tvoj fajl ponovo snimiti i pokušati pokrenuti ono dugme.

Hi,

Trying to use your setup and I have a problem.
when I move the axis z manually, it moves correctly (speed and acceleration is correct)
In the program, when the axis z going down in search of material (float switch) screwed up a lot higher speeds exceeding the capabilities of the machine.
I would add that in all axes have trapezoidal screw 4mm powered by the same engine and the same drivers.

Changing the settings for axis 2 affects the work in manual mode, but not automatic.

Any idea?

By the way, the manual does not mention setting the enable signal for drivers

I have found the solutions:

in stepper.hal

line:
#setp stepgen.2.maxvel [AXIS_2]MAX_VELOCITY

We need to remove #

I thought i wrote an explanation about that on the howto file ???? I don't remember now but i am glad you made it work.
Now if you could be bothered to share some pictures of your setup, it would be nice.
Let us know how it goes.
Regards,
Tom

Tom,

I am setting up my homebuilt CNC (in Scotland) using a proma-elektronika DTHC and am using your config files, with pins changed to match my setup. Test mode on Proma gives the correct UP, DOWN, and ARC OK signals visible in Linuxcnc. I can't get the system out of ESTOP; the ESTOP connections are spread across two separate .hal files and I'm not sure how to configure them. The pin is correct as tested with a different config for the same machine. Halfiles attached - can you help me with this?


Andy

My bad, I had uncommented some estop-related things and when I returned them to the same as in the downloaded .hal files it worked ok. Now wrestling with trivkins vs gantrykins - my machine's happy on trivkins in another configuration. Can't get the axes to jog at the moment.

a