New Setup - Moving From Mach 3
05 Apr 2021 17:26 #204924
by megaplow
New Setup - Moving From Mach 3 was created by megaplow
Hey all,
It is time for me to more from Mach3 to a new system. I was thinking about going the Mach4 route and decided LinuxCNC is the way to go. Can you please suggest a good computer and machine controller combo? I am most likely going to be using an ethernet solution. I was hoping for some sort of all-in-one that could get the job done.
Thanks!
It is time for me to more from Mach3 to a new system. I was thinking about going the Mach4 route and decided LinuxCNC is the way to go. Can you please suggest a good computer and machine controller combo? I am most likely going to be using an ethernet solution. I was hoping for some sort of all-in-one that could get the job done.
Thanks!
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19209
- Thank you received: 6438
05 Apr 2021 20:20 #204951
by tommylight
Replied by tommylight on topic New Setup - Moving From Mach 3
HP 8300 SFF and one of the Mesa cards, 7i92 or 7i96 or 7i76E or even the new ones like 7i95.
The following user(s) said Thank You: megaplow
Please Log in or Create an account to join the conversation.
05 Apr 2021 21:17 #204966
by megaplow
Replied by megaplow on topic New Setup - Moving From Mach 3
A whole setup for around $400, that is great, thank you @tommylight! Now going down the Mesa rabbithole...
The following user(s) said Thank You: tommylight
Please Log in or Create an account to join the conversation.
Time to create page: 0.064 seconds