Where is scripts/rip-environment on linuxcnc-2.7-wheezy

AndrewHsasku wrote: I am fed up with lack of documentation and sense in LinuxCNC.

A more common complaint is that there is too much documentation, so perhaps you haven't found it?

linuxcnc.org/docs/2.7/html/

The Wiki is user-generated and a lot if it was generated by users 10 years ago. I would take _everything_ on the Wiki with caution.

The docs in the link above are maintained, and should be correct.

You almost certainly don't need, or want, rip-environment on a typical installation.

Yes andypugh, you probably got a point.
Finally it turned out that there was some problem in .c that I compiled.
Halcompile didn't printed any error message. Starting linuxcnc resulted in error. Recompiling .c didn't fixed this error until a few reset of a whole computer. Error ("Module is in use") was printed for any configuration not matter if it was mine or simulation configuration.
Sad, but it would save a lot of time if I was not looking for rip-environment, because it mention in some post that I read, but focused on compilation itself.