Cannot Install Linux cnc Wheezy 2.7

I recently installed Linux cnc Wheezy 2.7 on my laptop HP probook 4530s and cannot work with it.
I install it as a test install on my laptop with usb drive and want to install Linux cnc on my desktop PC but I am unable to install it with USB drive.

my desktop PC
processor is Pentium D 3.4GHz and 1GB ram.
My motherboard www.biostar.com.tw/app/en/mb/introduction.php?S_ID=500

I changed several hard disks and data cables but nothing happen.
It loads the window of selecting the install method and after that stuck.
I used universal USB installer to make a bootable file.

You can try a Linuxcnc install using Stretch
www.linuxcnc.org/testing-stretch-rtpreempt/

Some laptops are usable with LCNC with preempt_rt and Mesa Ethernet cards. Otherwise the laptop power management tends to get in the way of RTAI.

I want to install to desktop pc

I have only worked with one Biostar mainboard in my life and the BIOS was terrible. You might have to try another motherboard.

tommylight wrote:

In BIOS set the "gate A21" to fast.
Or was it 20 ???

What is it?
I don’t heard before,

Bari wrote:

You can try a Linuxcnc install using Stretch
www.linuxcnc.org/testing-stretch-rtpreempt/

Some laptops are usable with LCNC with preempt_rt and Mesa Ethernet cards. Otherwise the laptop power management tends to get in the way of RTAI.

Is this like debian?
Once I seen on a Tommylight’s YouTube video he used IBM thinkpad laptop

Yes, after Wheezy IIRC there is Stretch and then Buster. Sid is the Debian new/unstable/likely supports you new hardware.

Some laptops are fine with LCNC using preempt_rt and mesa Ethernet FPGA cards.