Debian or Mint for Linuxcnc?
25 Jun 2020 23:42 #172765
by Catch22
Debian or Mint for Linuxcnc? was created by Catch22
So I've read that I should use Debian if going to use Linuxcnc because it's the most stable with it. But it seems like it's easier to use Linux Mint 19.3.
Is there really a difference between the two if only going to run Linuxcnc on the computer.
Is there really a difference between the two if only going to run Linuxcnc on the computer.
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19203
- Thank you received: 6437
26 Jun 2020 09:54 #172785
by tommylight
Replied by tommylight on topic Debian or Mint for Linuxcnc?
No difference, besides Mint is more user friendly and looks better.
The following user(s) said Thank You: Catch22
Please Log in or Create an account to join the conversation.
26 Jun 2020 11:05 #172790
by Aciera
Replied by Aciera on topic Debian or Mint for Linuxcnc?
Same here. I've had both and prefer mint for ease of installation and use. Mind you there is also a mint debian edition (LMDE) and depending on where ubuntu ends up going that might become used more often. But really you can't go wrong with the prepared mint ISO images.
The following user(s) said Thank You: Catch22
Please Log in or Create an account to join the conversation.
Time to create page: 0.109 seconds