1. LinuxCNC
  3. Installing LinuxCNC
  5. LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15

LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15

More
23 Feb 2021 12:33 #199819 by andypugh
Replied by andypugh on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15

By freeing memory 2.8.1 starts fine, but a lot of gpio from my 7i69 are not taken into account. ?


I was testing with a 7i69 last night, and I have to say that it seemed a bit weird in mode 3. (input states changing to match outputs, without even being wired to anything)

(After a few minutes of switching on, the parasitic cursors of my OLED disappear ??)


I don't have a 7i73 that isn't buried deep in a machine at the moment to test with.

Please Log in or Create an account to join the conversation.

More
23 Feb 2021 16:17 #199845 by gaston48
Replied by gaston48 on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15
2.9.0 is installed, there is no more memory limit now. :)
A lot of my 7i69's gpio are inconsistent. Both are in mode 0. green leds of
watchdog is good. The 7i73 in mode 2
(the parasitic cursors of my OLED is persistent now, but that's a detail)

Please Log in or Create an account to join the conversation.

More
22 Sep 2022 13:36 #252568 by gaston48
Replied by gaston48 on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15
Hello Andy ,
When will a release of version 2.8 have enough HAL memory  please  ?

Please Log in or Create an account to join the conversation.

More
22 Sep 2022 20:39 #252586 by andypugh
Replied by andypugh on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15
It probably won't, I don't anticipate any more 2.8 releases.

Please Log in or Create an account to join the conversation.

  1. LinuxCNC
  3. Installing LinuxCNC
  5. LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15
Time to create page: 0.069 seconds
Powered by Kunena Forum