Enhancing latency on Virtual box
- kareem.fadly
- Offline
- New Member
-
Less
More
- Posts: 1
- Thank you received: 0
20 Jul 2024 19:19 #305718
by kareem.fadly
Enhancing latency on Virtual box was created by kareem.fadly
I am newbie to LinuxCNC, I wanted to have it first on virtual machine.
Unfortunately I am getting too high latency results. Tried to adjust the virtual box settings: reduce number of CPUs, disabling network adapter and USB. It enhanced from 15ms to 10ms. But still too far.
Can anyone who has experienced similar issue share with me how to resolve it?
Unfortunately I am getting too high latency results. Tried to adjust the virtual box settings: reduce number of CPUs, disabling network adapter and USB. It enhanced from 15ms to 10ms. But still too far.
Can anyone who has experienced similar issue share with me how to resolve it?
Please Log in or Create an account to join the conversation.
20 Jul 2024 19:48 #305720
by PCW
Replied by PCW on topic Enhancing latency on Virtual box
You can certainly run LinuxCNC in simulation mode in a virtual box,
but its not likely that you can run an actual machine that way.
Normally LinuxCNC requires latencies considerably less than 1 ms.
but its not likely that you can run an actual machine that way.
Normally LinuxCNC requires latencies considerably less than 1 ms.
The following user(s) said Thank You: kareem.fadly
Please Log in or Create an account to join the conversation.
Time to create page: 0.088 seconds