Arc move in concave corner cannot ....(again)
- nilsht
- Offline
- New Member
-
Less
More
- Posts: 10
- Thank you received: 0
24 Feb 2016 18:33 #70581
by nilsht
Arc move in concave corner cannot ....(again) was created by nilsht
Hi,
When trying to run my program I get the message "Arc move in concave corner cannot be reached by the tool without gouging".
My problem is that I cant see what should cause this message.
If I ignore the message and run the program anyway it stops after ~4mm of a 6mm deep circular pocket.
The error is supposed to be near line 2899 of pastebin.com/x15daqQ2
Any help appreciated!
When trying to run my program I get the message "Arc move in concave corner cannot be reached by the tool without gouging".
My problem is that I cant see what should cause this message.
If I ignore the message and run the program anyway it stops after ~4mm of a 6mm deep circular pocket.
The error is supposed to be near line 2899 of pastebin.com/x15daqQ2
Any help appreciated!
Please Log in or Create an account to join the conversation.
- nilsht
- Offline
- New Member
-
Less
More
- Posts: 10
- Thank you received: 0
24 Feb 2016 19:50 #70583
by nilsht
Replied by nilsht on topic Arc move in concave corner cannot ....(again)
OK, found the problem!
Looks like my CAM didnt update my G41's when I changed tool to be used.
Looks like my CAM didnt update my G41's when I changed tool to be used.
Please Log in or Create an account to join the conversation.
Time to create page: 0.066 seconds