MPG simulation Gmoccapy
- manager12345
- Offline
- Junior Member
-
Less
More
- Posts: 29
- Thank you received: 1
25 Nov 2023 05:43 - 25 Nov 2023 06:34 #286438
by manager12345
MPG simulation Gmoccapy was created by manager12345
Hello everyone I want to use Gmoccapy for a simulation stand, but I ran into such a problem that I can't process MPG signals to move along the axes. Do you have any ideas how I can implement this?
I tried to set a coefficient in encoder.positon and output it to axis.N.jog-scale, but it didn't end with luck. I'm thinking of using sim axis hardware, for conversion and movement. Can I do it?
I tried to set a coefficient in encoder.positon and output it to axis.N.jog-scale, but it didn't end with luck. I'm thinking of using sim axis hardware, for conversion and movement. Can I do it?
Last edit: 25 Nov 2023 06:34 by manager12345.
Please Log in or Create an account to join the conversation.
25 Nov 2023 11:49 #286448
by Aciera
Replied by Aciera on topic MPG simulation Gmoccapy
I think you would want to use encoder counts rather than position
Have a look here:
www.forum.linuxcnc.org/gmoccapy/41189-mp...gmoccapy-help#195906
Have a look here:
www.forum.linuxcnc.org/gmoccapy/41189-mp...gmoccapy-help#195906
Please Log in or Create an account to join the conversation.
27 Nov 2023 13:45 #286620
by HansU
Replied by HansU on topic MPG simulation Gmoccapy
You want to use a hardware encoder / MPG that should control you simulation? Or how exactly does your setup look like?
Please Log in or Create an account to join the conversation.
Time to create page: 0.066 seconds