Highlighted gcode doesn't follow current position.

This is it.

After posting that image of the g code I believe I see it now. The % symbol is on line 5. So that would explain everything being off set considering the line is starting at 1...
I knew it had to have been something silly.

Update: That was it.... image missing /media/kunena/emoticons/grin.png

tommylight wrote:

Upload a picture of the whole screen.

Aciera wrote:

Also, please post the gcode

You did neither, seems you are hiding something...
Yet you ask us for help.

TheTinkeringMechanic1 wrote:

After posting that image of the g code I believe I see it now. The % symbol is on line 5. So that would explain everything being off set considering the line is starting at 1...
I knew it had to have been something silly.

Update: That was it.... image missing /media/kunena/emoticons/grin.png

Thank you for reporting back.

tommylight post= You did neither, seems you are hiding something...
Yet you ask us for help.

I have to trim the size of the image down otherwise I get an error saying the image is too big.
If for some strange reason I decide against my better judgment to come back here again and ask a question, do me a favor, don't reply to it.
I really don't care if you know the answer. I am going to ignore anything you post from here on out. If it was possible to block you from seeing anything I post here, I would. 

Have a day you deserve.
 

To analyze problems with gcode, it is so much easier to load the relevant file into your own simulation and test it than to look at a screenshot and make some assumptions...