Need help with the orient component for spindle activation (M19)

and it is always the same value that are ingest for ORIENT, no I do not think that it is problematic for the continuation, it is to have the 0 on a lathe and perhaps a milling machine (it has 100 years); in any case, I would like to thank you for your work on the demo VISMACH and more recently on this project, thank you again, Andy!

Good evening, so that "ORIENT" is not more allergic with certain values, I replaced that:

setp near.0.difference  0.0005

by 

setp near.0.difference  0.0006

Could you post how all the files turned out, from the fuzzy orientation you made? the ini file and the hal files. I tried here with the ones you described, but I couldn't.

hello, I try to post you the complete configuration tonight, it works very well (not yet on the machine -test empty-) try also on version 2-8-4

Thanks friend, I'll wait.

hello, sorry, I didn't have time last night, tonight you have it

... 

good morning my friend
Are you sure these files work?
It seems to be different from the other posts.
I tried here, but it didn't work.
I am using version 2.8.3 and 2.8.4.

hello, yes very good, works on and created on the 2-7-15 and tested also on the 2-8-2 maybe you have only one control card, then you have to "comment" some lines (#) such as parport 1 if you have no MPG