Axis Position Logger

More
2 years 7 months ago #296056 by partec
Replied by partec on topic Axis Position Logger
but sure, of course flawless, thank you very much!

Would you possibly have free capacity for the commercial development of a special control?

Please Log in to join the conversation.

More
2 years 7 months ago #296064 by Aciera
Replied by Aciera on topic Axis Position Logger

Would you possibly have free capacity for the commercial development of a special control?

Your question honors me but I'm not a programmer and I only do this on the side. 

Please Log in to join the conversation.

More
2 years 7 months ago #296115 by Aciera
Replied by Aciera on topic Axis Position Logger
I renamed this to 'lcnc_logger' and put this on my GitHub page so it does not interfere with the original version:
github.com/Sigma1912/lcnc_logger

Also I added 'motion.digital-out-xx' and 'motion.analog-out-xx' as possible log triggers:
 

Attachment not found

Please Log in to join the conversation.

More
1 year 9 months ago #318939 by Ehsan_R
Replied by Ehsan_R on topic Axis Position Logger
How can I add lcnc_logger to the user interface?
Code:
[code]EMBED_TAB_NAME = lcnc_logger MBED_TAB_LOCATION = ntb_user_tabs EMBED_TAB_COMMAND = gladevcp -c gladevcp -u lcnc_logger.py -H manual-example.hal lcnc_logger.ui
[/code]

Please Log in to join the conversation.

More
1 year 9 months ago #318943 by Aciera
Replied by Aciera on topic Axis Position Logger
Not sure but I doubt it's possible to embed a PyQt window in gmoccapy.

Please Log in to join the conversation.

More
1 year 5 months ago #327518 by fery15sty
Replied by fery15sty on topic Axis Position Logger
how to run lcnc_logger? what to add in .ini file?

Please Log in to join the conversation.

More
1 year 5 months ago #327524 by Aciera
Replied by Aciera on topic Axis Position Logger
you need to execute 'lcnc_logger.py' with linuxcnc running. This can also be done using a custom mcode as outlined here (note that the file has since been renamed to 'lcnc_logger.py') :
forum.linuxcnc.org/21-axis/30986-axis-po...gger?start=60#294514

Please Log in to join the conversation.

More
1 year 5 months ago #327988 by fery15sty
Replied by fery15sty on topic Axis Position Logger
can this g2/g3 line use radius type R and not use i, j, k?

 

Attachment not found

Please Log in to join the conversation.

More
1 year 5 months ago #327992 by Aciera
Replied by Aciera on topic Axis Position Logger
Not as it is. It would have to be added to this part of the code (unfortunately I'm rather busy with other things right now):

 

Attachment not found

Please Log in to join the conversation.

More
1 year 5 months ago #327996 by fery15sty
Replied by fery15sty on topic Axis Position Logger
ok, i have tried editing the code to change it to R. after many errors finally it worked..

Thanks

 

Attachment not found



and the results


 

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.197 seconds
Powered by Kunena Forum