Axis 2 - touchscreen version of old friend

Tkank you Zack i will load this new on and let you know

wow this looks very nice, just the way I had it in my head, thank you very much I can't wait to try it

you must use the new attached file in the reply above for requested changes and put it in user/share/axis/tcl with privileges

Ok.I'm not in the workshop right now, but I'll be there during the day and report back..

that is it ,everything works except vfd spindle speed reading rpm, it stays at zero. I tried to insert a custom pyvcp spindle panel, but then it gives me an error that the ``spindle-speed'' line is duplicated. I would like to ask for one more if it is not difficult, is it possible to add another custom MDI because I need another control (m65 p0) independent that will turn off the relay for changing the mode between A and S (for me, the axis and spindle work with the same driver and I often change his mode) thank you 

Please send another screenshot, try change the color please.Your file attached. 

great, vfd again doesnt show rpm, but in gladavcp it show.
 

ok post your hal files etc
the spindle could be configured to a different pin or it may be spindle 2/3 or so on
i need to see your ini and hal files along with glade panel if possible.

thanks Zack, here I have attached the files

Try this please - attached below