Schaublin 125-CNC retrofit.

Thanks guys. Pulling the USB seems to do the trick. Sad how my brain wont retain the simplest of solution

 

It took a fair bit of dicking around to get UEFI deactivated and Linux reinstalled, but the latency is now way better. Thanks a lot for the suggestion Tommy.
  1
Now I have to remember what I did to connect to the 7i92 a couple of days ago Wish me luck!
Mark

That NM-tray applet is really flaky. I have two instances in the task bar now, but saw up to 6 instances before. On my install, right clicking, and selecting "edit connection" does nothing.

nm-connection-editor &
brought up the window to edit the IPv4 settings on my last OS install, but now gives a "command not found".
 

Any ideas how else I can get in to edit the IPv4 config to change the IP to 10.10.10.11?
Mark

 

Running nm-tray --help, and then clicking on the trays "edit connection" button, returned this...
 

... which tells me the editing window didn't start (no shit!). Any ideas how to address this appreciated.
Mark

Search the forum i think Bevins posted something about stopping NM from running several instances.
sorry i have to run.

Seems there was a similar bug in Ubuntu in 2018, that NM-Tray calls xterm as the editor, and xterm is not installed.wonder what I can break with sudo apt-get install xterm......
okay that worked (once I move the pc up into the office and reconnected to the internet).
Xterm has to be the ugliest editor ever.
But I can finally connect back up to the 7i92. WooHoo!
I again made a PNFConf HAL hal, and then removed everything but the header.
I still dont have any 7i73 pins, and it still has that red watchdog LED glaring at me. What is the correct syntax for the sserial_port call?
I have tried the one below, but also 0000000.

loadrt [EMCMOT]EMCMOT servo_period_nsec=[EMCMOT]SERVO_PERIOD num_joints=[KINS]JOINTS
loadrt hostmot2
loadrt hm2_eth board_ip="10.10.10.10" config=" num_encoders=5 num_pwmgens=1 num_stepgens=2 sserial_port_0=0000xx"
setp hm2_7i92.0.watchdog.timeout_ns 5000000

Peter sorted me out in this thread...
forum.linuxcnc.org/27-driver-boards/4430...-boards-dont-show-up
 

9 1/2 hr late but, I managed to get a summary of a week of trying to relearn how to setup LinuxCNC.

Hi Tommy, is your youtube channel TomaCNC? I didn't realise. I'll add a link.

Yup, also on youtube:
toma berisha
toma cnc
toma 3d
and on instagram
toma.cnc
toma.pc
toma.3d