Mesa 7i95

Hi,
thanks for reply. It requires 9-30v

Take a look at this thread:

forum.linuxcnc.org/38-general-linuxcnc-q...onnect-7i96-to-a-vfd

Thanks, I was thinking simple mosfet level shift but I think I will go for opto just for extra safety.

One more question where do I find the latest bit file/ source files for the 7i95? is the latest on your website or somewhere on Git?
(I am sure it has been answered milion times but I am useless at finding the answer.)
thank you

Any FPGA card zip file will have the sources for all FPGA cards

ok the once on your website?

www.mesanet.com/software/parallel/hostmot2.zip

Thank you

Hey,

- Mesa 7i95
- LinuxCNC 2.9 installed
- mesaflash updated according to github howto

I can ping the card but can´t read the hmid:
 

Any suggestion what to do next?

You have your PC's IP address set to the 7I95s address so the ping
response is coming from your PC. The host PC IP address
has to be different but in the same subnet, say 192.168.1.100.

Also you don't need sudo for Ethernet cards.

My card is also not being recognized in the top right corner. Maybe my network manager is the problem? I am missing a wired connection 1.