New Project with Mesa 7I96 and THCAD-05

More
5 years 4 months ago #210961 by TexasCNC
Replied by TexasCNC on topic New Project with Mesa 7I96 and THCAD-05
Got it didn’t know I could edit ok now I install which one?

Please Log in to join the conversation.

More
5 years 4 months ago #210962 by phillc54
Replied by phillc54 on topic New Project with Mesa 7I96 and THCAD-05
You should be able to do a normal update routine like before.

Please Log in to join the conversation.

More
5 years 4 months ago #210963 by TexasCNC
Replied by TexasCNC on topic New Project with Mesa 7I96 and THCAD-05
But do I install I went through the steps and it had me remove the linuxcnc on there. Now it’s asking to install linuxcnc.

Please Log in to join the conversation.

More
5 years 4 months ago #210964 by phillc54
Replied by phillc54 on topic New Project with Mesa 7I96 and THCAD-05
Sorry, yes, just follow the steps and it will get you there...

Please Log in to join the conversation.

More
5 years 4 months ago #210965 by TexasCNC
Replied by TexasCNC on topic New Project with Mesa 7I96 and THCAD-05
I was t suppose to remove my existing linuxcnc right? Now I need to start all over again?

Please Log in to join the conversation.

More
5 years 4 months ago #210966 by phillc54
Replied by phillc54 on topic New Project with Mesa 7I96 and THCAD-05
Just uninstall it then install it exactly like on the Buildbot page. It does not affect any configs.

Please Log in to join the conversation.

More
5 years 4 months ago #210967 by TexasCNC
Replied by TexasCNC on topic New Project with Mesa 7I96 and THCAD-05
Ok I went to open the GUI now gives me a error on file ./plasmac.tcl
Pin halui.spindle.0.stop was already linked to signal spindle-manual -stop

Please Log in to join the conversation.

More
5 years 4 months ago #210968 by phillc54
Replied by phillc54 on topic New Project with Mesa 7I96 and THCAD-05
Did it tell you plasmac was update and you need to restart linuxccnc?

If yes the run linuxcnc again, if not can you post the machine hal file and the connections hal file.

Please Log in to join the conversation.

More
5 years 4 months ago #210970 by TexasCNC
Replied by TexasCNC on topic New Project with Mesa 7I96 and THCAD-05

phillc54 wrote: Did it tell you plasmac was update and you need to restart linuxccnc?
No it didn’t tell me to
If yes the run linuxcnc again, if not can you post the machine hal file and the connections hal file.

Let me see if I can copy them over

Please Log in to join the conversation.

More
5 years 4 months ago #210971 by TexasCNC
Replied by TexasCNC on topic New Project with Mesa 7I96 and THCAD-05

Attachment not found

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.226 seconds
Powered by Kunena Forum