New Project with Mesa 7I96 and THCAD-05

It looks like it couldn't find ohmic.com You probably need to be in the same directory as ohmic3.comp when you run halcompile or maybe enter the full path to ohmic3.comp

Nope didn’t work tried putting the whole path and gave me a error. Is there a more easier way to install this? Got my z motor and did a cut and the thc still didn’t work. I checked all the setting ls and they all look correct my wiring to the cards are good. Going to put this Mesa setup aside and just buy a plug and play system. This stuff just takes up too much time trying to set it up. Will hook this up to my working machine later but for now I want the new table to be working will be buying a plug and play system. Thanks to the guys that replied to my issues and helped solve most of them I know the system works good and I thought it would work out for me but it’s just tough trying to learn all the Linux stuff and editing configs

you might need to use sudo halcompile --install ./ohmic3.comp
Sometimes linux needs the "./" before a filename to tell it to look in the current directory

I have tried to compile ohmic3 and it will not work I used both examples for the command line entry. I also have problems getting the key in the buildbot routing Phillc posted

Wrong folder, that has to be run on the folder where ohmic3 is located.

I would be wonderful to know where the folder is.
And that is only one of the problems shown.

locate ohmic3

should help (assuming you are not running a RPI or other similar CPU)

I am running a Dell optiplex, I just ran a find in the terminal and ohmic3 is not on this system.

ohmic3 does not seem to be a part of LinuxCNC

Were you supposed to have downloaded it from somewhere?

acourtjester wrote: I also have problems getting the key in the buildbot routing Phillc posted

I am getting the same, it seem the keyserver has been taken offline. sks-keyservers.net

Edit2: This is probably the more correct one:
This one seems to be ok for the moment:
Edit1: This one looks ok as well: