Re:pncconf - feature requests

Thank You very Mutch
it is always a Good idee to Mark Images on the image if they show Some Pinouts

Hi,
Is there any news on when 7i97 will be supported for the 7i97?

Chris,

What app are you using to draw that board? I need to document the wiring of my machine and I don't have a tool that makes it easy to draw a simple diagram.

Thanks
John

shadab wrote: Hi,
Is there any news on when 7i97 will be supported for the 7i97?

It's not on my radar currently, but if someone could post the output from mesaflash for it's pins and sserial that might motivate me.
Chris

JohnnyCNC wrote: Chris,

What app are you using to draw that board? I need to document the wiring of my machine and I don't have a tool that makes it easy to draw a simple diagram.

Thanks
John

IIRC, I didn't draw it I colored it and changed some labels.
I might of taken a different card's image and edited it.

I use GIMP, which is not friendly if you only use it once in a while.

Chris

Thanks, I've used Eagle CAD but that is way to complicated for doing a simple wiring diagram and MS Paint is way too primitive. I guess I have some Googling to do.

John

cmorley wrote:

shadab wrote: Hi,
Is there any news on when 7i97 will be supported for the 7i97?

It's not on my radar currently, but if someone could post the output from mesaflash for it's pins and sserial that might motivate me.
Chris

Hi Chris,
We are working with 7i97 to retrofit a HURCO Hawk 30 as discussed in this forum post and might be able to help you get the data you need. Let us know what data you need and we will send it to you.


Shadab

looking for the output from these commands (address might be different for yours)
mesaflash --device 7i97 --addr 192.168.1.121
mesaflash --device 7i97 --addr 192.168.1.121 --sserial
mesaflash --device 7i97 --addr 192.168.1.121 --readhmid

Hi Chris,
The reponses from mesaflash for the following commands:

mesaflash --device 7i97 --addr 10.10.10.10

ETH device 7I97 at ip=10.10.10.10

mesaflash --device 7i97 --addr 10.10.10.10 --sserial

SSLBP port 0:
SSLBP Version: 1.43
SSLBP Channels: 1
SSLBP Baud Rate: 2500000

I have attached the output of -readhmid command below:


Thanks,
Shadab

Renumber PNC conf inputs and outputs to match screen masking on the cards the drivers support. this off by one thing is kind weird, it also create a room for more errors. The screen masking of the Board should match the numbering of the driver IO etc. Remember, NASA lost a mars mission of a converison error.