Buildbot repositories down?

Should be back now. It had run out of disk space.

Buildbot repositories are up again

Thx a lot

hey andy, you ever considered a mirror? what are your bandwidth requirements and monthly/daily load? miiiiiiiiiight be able to help

Yes, it works again. Thank you!

oddwick wrote: hey andy, you ever considered a mirror? what are your bandwidth requirements and monthly/daily load? miiiiiiiiiight be able to help

The Buildbot is nothing to do with me. I think it runs in Seb's garage.

ahhh, for some reason i was under the impression that you maintained the server.

Forgive me for jumping the wrong thread here... but im battling to install master 2.9 using this instructions buildbot.linuxcnc.org/

no errors reported but master or 2.9 doesnt show up in Synaptic after reloading and adding repositories.

i tried:
deb buildbot.linuxcnc.org/ stretch 2.9-rtpreempt
deb-src buildbot.linuxcnc.org/ stretch 2.9-rtpreempt

and

deb buildbot.linuxcnc.org/ stretch master-rtpreempt
deb-src buildbot.linuxcnc.org/ stretch master-rtpreempt

I also tried manually adding them to sources.list, but still no luck

I am starting with a fresh install from the stretch rtpreempt .iso. => 2.7.15

i also ran apt-get update and apt-get upgrade

1st time for my trying to do a major version upgrade, some advice will be appreciated

thanks

Henk

They don't seem to be
buildbot.linuxcnc.org/dists/

It would definitely be master-rtpreempt

Have you added the buildbot signing key as described on the buildbot.linuxcnc.org page?

This one?

sudo apt-key adv --keyserver hkp://keys.gnupg.net --recv-key EF1B07FEE0EE663E

Yes i did. I have followed the buildbot instructions verbatim, or at least i intended to...

Did it again, and edited the sources.list to contain only 2.7 and master-rtpreempt
Removed 2.7 in synaptic by using "complete removal" and ran the reload....and it seemed to have worked now,
Synaptic now show 2.9

Thanks