Smaller hbox_jog [SOLVED]

Hello,

If I change size of DRO, Gmoccapy screen is bigger then my monitor.
I need make smaller hbox_jog (area 2)
I will have physical buttons, so I will never click on virtual buttons, but I want see slider.

I don't know how to accomplish what you want, but I think that box (#2) is shared with the g-code and MDI displays while in Auto/MDI modes.

If you squeeze down box #2 to get rid of the HMI jog controls you'll not have much real estate to see more than a couple lines of gcode.  You OK with it like that?

I didn't realize that my g-code line count was going down. I'll probably need both. Reduce the number of lines and simultaneously reduce

My DRO is very small. I am not opposed to other proposals. The photo shows a simulation with XYZ. I actually have XYZA there.

 

Not sure if you are aware, but you can change the DRO character/font size in the gmoccapy settings page.  Try increasing to 50 or so and see if that helps out.

I've also found that some of the windows/boxes are size-adjustable simply by hovering and dragging the edge of the windows.

If I increase the DRO, the horizontal buttons disappear.

I think this does what you want. It hides the jog buttons but keeps the slider for the jog rate. The documentation is a bit unprecise at this point, I must admit.

 

You mean the bottom row buttons?  Not good.

I hope someone else more familiar with gmoccapy can chime in 'cause I'm out of ideas on how to modify the screen to get you a bigger DRO.

Maybe there's a way to get rid of the spindle on/off buttons in box #6 to make it smaller.  Sounds like you want physical buttons for jogging - maybe for spindle control too?  If those huge spindle buttons were gone, that'd get you a fair bit of room to shift everything around and get a larger DRO.

Who deleted Hansu's post?
I restored it, let me know if it needs deleting.
Thank you.

tommylight wrote:

Who deleted Hansu's post?
I restored it, let me know if it needs deleting.
Thank you.
 

It was me . I wanted to wait until I can test it to give a more certain answer Sorry for the confusion. I have updated the post now.

No worries, just making sure.
Since most of us who check here often are on mobile phones, plenty of space ... hmmm for mistakes.
Maybe plenty was not the right word