Photos

thefabricator03 wrote: I cut these for a project. They are decorative outriggers. Cut from 1.6 hot rolled sheet. I welded them and then ground them flush and had them powder coated.

I need some of them to replace my rotting fascia. DO you make house calls?

rodw wrote:
I need some of them to replace my rotting fascia. DO you make house calls?

Sure anything is possible... For a price Lol

This one I get 10 out of a sheet if Index it on my 1/2 sheet table

Thes parts are then essentially free now as I cut them from the waste

And the nest complete with 2 sever cuts

Looks good Rod, Free parts are always the best.

@Rod,
Daymn, those are nice!

thefabricator03 wrote: Looks good Rod, Free parts are always the best.

And I have bucketloads more than I need. I cleaned up 100 of each out of the last batch but I don't really need to powdercoat them yet..

The long bracket has a slight bend in it which I do in a 6" vice press brake now but I was paying about $15 a set of 2 with the powdercoating so I am way in front..

I guess its time I put something on here. 1.6mm sheet, around 500mm x 405mm (16Ga 19.5" x 16")

Great job Phill,

The wife got her way after all, Lol.

thefabricator03 wrote: The wife got her way after all, Lol.

haha, no this was for my daughter.

Was it normal cold rolled sheet or galvanized? Did you powder coat or just spray paint?