Photos

Gal, sprayed with Wattyl Kill Rust from a can.

very nice

FINALLY, i know where all the deer are hiding !
Very nice, indeed.

tommylight wrote: FINALLY, i know where all the deer are hiding !

If they end up where this sign is going they will have been converted to venison.

phillc54 wrote:

tommylight wrote: FINALLY, i know where all the deer are hiding !

If they end up where this sign is going they will have been converted to venison.

Now thats a conversion I like!

rodw wrote:

phillc54 wrote:

tommylight wrote: FINALLY, i know where all the deer are hiding !

If they end up where this sign is going they will have been converted to venison.

Now thats a conversion I like!

Rod .You have enough road kill to feed the 40K I saw over a hundred on the drive to Phill's

Clive S wrote:
Rod .You have enough road kill to feed the 40K I saw over a hundred on the drive to Phill's

When you come to Aus, you can take all the road kill you want. As long as its Kangaroo. There are everywhere! Our Semi makes a mess of them daily.

thefabricator03 wrote:

Clive S wrote:
Rod .You have enough road kill to feed the 40K I saw over a hundred on the drive to Phill's

When you come to Aus, you can take all the road kill you want. As long as its Kangaroo. There are everywhere! Our Semi makes a mess of them daily.

Thats the thing, he did come and saw his mates but drove right past you without stopping! I can't report on his eating habits but I did make sure he was fed before tackling the said road kill. But I would say what you observed Clive was nothing by comparison with what you would see further inland in the real outback!

This was something I did up a while ago so the carriers could find me. Painted mild steel on an ally background drilled and tapped to the building fame. I used sheetcam so for the background I just needed to move the inside elements to a new layer which was not cut to make the backing plate. Really should have powdercoated it!

Not as pretty as Phill's though!

Been using plasmac since I started, which coincidentally was right when Plasmac was getting started. I think I struggled a few months without proper THC and a low cost chinese plasma cutter before taking it seriously and luckily development on Plasmac took off. Here's a couple of my favorites I've made over the years, as well as an album with the rest of them.

These were finished with SteelFX patinas.

Album for more: photos.app.goo.gl/BKWHcRQABQVQAEwh8