PlasmaC questions new setup

More
6 years 4 months ago #171700 by phillc54
Replied by phillc54 on topic PlasmaC questions new setup
Just compress the complete directory.

Please Log in to join the conversation.

More
6 years 4 months ago #171701 by tecno
Replied by tecno on topic PlasmaC questions new setup
How, there not to be any Zip

Please Log in to join the conversation.

More
6 years 4 months ago #171704 by tecno
Replied by tecno on topic PlasmaC questions new setup
Novice here :(

Attachment not found

Please Log in to join the conversation.

More
6 years 4 months ago #171705 by phillc54
Replied by phillc54 on topic PlasmaC questions new setup
Right click on the file and then click Compress

Please Log in to join the conversation.

More
6 years 4 months ago #171707 by phillc54
Replied by phillc54 on topic PlasmaC questions new setup
Try changing these in the Config Panel:
Code:
Probe Speed 400 Probe Height 40 Safe Height 40 Setup Speed 2000

Please Log in to join the conversation.

More
6 years 4 months ago #171708 by rodw
Replied by rodw on topic PlasmaC questions new setup
You can sort this out doing a G54 touchoff.
I have 86mm travel so I went to the top of travel and touched off the Z axis at 86mm and I've never touched it for years. That means that it is 0.0 at the bottom of travel

Please Log in to join the conversation.

More
6 years 4 months ago #171710 by tecno
Replied by tecno on topic PlasmaC questions new setup
Pling.............................................. G54

Looks as it works now. Need to do some maintenance as all 4 screws holding the stepper where ripped out LOL Made some errors obviously.

Problem must be the fixed value 40 of feedrate in Run Panel.

Where do I set Safe Height?

Please Log in to join the conversation.

More
6 years 4 months ago #171715 by phillc54
Replied by phillc54 on topic PlasmaC questions new setup
In the Config Panel, top right.

Please Log in to join the conversation.

More
6 years 4 months ago #171717 by tecno
Replied by tecno on topic PlasmaC questions new setup
:(

Happy too early, now its the same as before Z stand still when it should go down and touch off and start cutting.

Please Log in to join the conversation.

More
6 years 4 months ago #171718 by phillc54
Replied by phillc54 on topic PlasmaC questions new setup
Did you change all the settings I posted. When I changed them to that here it worked fine. You then need to save them.

Please Log in to join the conversation.

Time to create page: 0.118 seconds
Powered by Kunena Forum