New Configuration Error

snowgoer540 wrote: Helping a guy run configurator to get his table going for the first time. Afterward, encountered this error on start-up "signal 'spindle-at-speed' not found".

It turns out that this line regarding the spindle was not commented out, and caused the problem:

Code:

sets spindle-at-speed true

Commenting it out solved the problem. If I recall, I think the configurator was recently updated to comment out spindle lines, it looks like perhaps one slid through the cracks.

Fixed...

phillc54 wrote:

snowgoer540 wrote: Helping a guy run configurator to get his table going for the first time. Afterward, encountered this error on start-up "signal 'spindle-at-speed' not found".

It turns out that this line regarding the spindle was not commented out, and caused the problem:

Code:

sets spindle-at-speed true

Commenting it out solved the problem. If I recall, I think the configurator was recently updated to comment out spindle lines, it looks like perhaps one slid through the cracks.

Fixed...

Good work. I think we'll let you stay on as lead developer! :laugh:

snowgoer540 wrote: Good work. I think we'll let you stay on as lead developer! :laugh:

Bugger...

phillc54 wrote:

snowgoer540 wrote: Good work. I think we'll let you stay on as lead developer! :laugh:

Bugger...

Don't be sad, it comes with a 100% pay increase!

snowgoer540 wrote:

phillc54 wrote:

snowgoer540 wrote: Good work. I think we'll let you stay on as lead developer! :laugh:

Bugger...

Don't be sad, it comes with a 100% pay increase!

Oh goody, now I'll be able to buy..... nothing

snowgoer540 wrote:

phillc54 wrote:

snowgoer540 wrote: Good work. I think we'll let you stay on as lead developer! :laugh:

Bugger...

Don't be sad, it comes with a 100% pay increase!

100% of current pay = ????
0 *200% = in the money!

rodw wrote:

snowgoer540 wrote:

phillc54 wrote:

snowgoer540 wrote: Good work. I think we'll let you stay on as lead developer! :laugh:

Bugger...

Don't be sad, it comes with a 100% pay increase!

100% of current pay = ????
0 *200% = in the money!

My biggest pay increase ever...

phillc54 wrote:

snowgoer540 wrote:

phillc54 wrote:

snowgoer540 wrote: Good work. I think we'll let you stay on as lead developer! :laugh:

Bugger...

Don't be sad, it comes with a 100% pay increase!

Oh goody, now I'll be able to buy..... nothing

Now THAT'S the spirit! :laugh:

(but you will have a sweet, robust software driving your plasma table )

rodw wrote:

snowgoer540 wrote:

phillc54 wrote:

snowgoer540 wrote: Good work. I think we'll let you stay on as lead developer! :laugh:

Bugger...

Don't be sad, it comes with a 100% pay increase!

100% of current pay = ????
0 *200% = in the money!

Checks in the mail!

Not sure if it matters, but the following line slipped through the cracks under the spindle section:
While I bring that up, should we comment out the maxerror lines in the .hal as well for stepper systems (I think this was just a stepper thing)? There could be a check box in the configurator for stepper vs servo system.

If it was a stepper system, we'd comment out the following lines (the only 4 with "maxerror" in them):