Configure PlasmaC with only one BOB

Can you confirm the following:

You do not have a breakaway switch.
You do not have a float switch.
You are using "parport.0.pin-11-in-not" for all-home and also for ohmic-probe-input.

What version of LinuxCNC are you using?

Edit:
You seem to be using an old version of PlasmaC, the debounce component was changed to the new dbounce component on September 11 last year.

YES (will come later)
YES (will come later)
YES

Version is 2.8.0

Try the two attached files, hopefully I got it correct. There are a couple of comments in the testplasmacnc_connections.hal that are dependant on whether you need a "in" or "in-not" for ohmic probing.
It is best when using PlasmaC to keep all your plasma specific connections in the testplasmacnc_connections.hal file which allows you to use StepConf to change config settings without changing any plasma connections.

Thanks for the help.

I decided to make ohmic sensor later.

I have now built a floating switch for start. Can someone tell me how the line in the connection.hal must look if the switch is connected to pin 11?

Thanks

net plasmac:float-switch parport.0.pin-11-in => debounce.0.0.in

i will try it immediately

ok it looks good. but i have to invert the signal.
parport.0.pin-11-in-not

If i do it, than i get message "...was already linked to signal XXX

Do you still have it linked to ohmic probe?

If so you will need to comment that line.

no, the pin is linked to my home switch

net all-home <= parport.0.pin-11-in-not

Try this instead:

net all-home => dbounce.0.0.in

Or change the contacts of the float switch.