Latest post processor

Anyone have the link for the latest post processor that works with QTPlasmaC?

post processor for what with QTPlasmaC (fusion360/sheetcam/feecad????)

there is this thread you can search
forum.linuxcnc.org/plasmac/38438-plasmac-post-processors


forum.linuxcnc.org/plasmac/36568-post-pr...-and-plasmac?start=0

Sheetcam has a postprocessor available as default in the current / more receint versions of shetcam although I did post it here (and was given some negative comment in the next post for doing it!):
forum.linuxcnc.org/plasmac/38438-plasmac...sors?start=10#215479

robertspark wrote:

Sheetcam has a postprocessor available as default in the current / more receint versions of shetcam although I did post it here (and was given some negative comment in the next post for doing it!):
forum.linuxcnc.org/plasmac/38438-plasmac...sors?start=10#215479

Possibly because that thread is for user donated postprocessors rather than copies of postprocessors from commercial products.